|
Evaluation License |
  
|
|
Evaluation License |
|
I can then provide for a specific lab scenario to get you started!
Enter the Global Configuration mode to set the hostname, secure the command line, and encrypt passwords. I can then provide for a specific lab
Every Cisco network deployment starts with securing the management plane of routers and switches. This lab covers initial device hardening. Topology Requirement One 2911 Router connected to one 2960 Switch. One PC connected to the switch. Configuration Steps (Router & Switch) This lab covers initial device hardening
Switch(config)# interface gigabitEthernet 0/1 Switch(config-if)# switchport mode trunk Switch(config-if)# switchport trunk allowed vlan 10,20 Use code with caution. Step 3: Configure Router-on-a-Stick (Inter-VLAN Routing) secure the command line
Configure hostnames, banners, passwords, and SSH access.
Several comprehensive guides provide step-by-step instructions and downloadable Packet Tracer files for the 200-301 syllabus: CCNA 200-301 Hands-on Mastery with Packet Tracer
Build Standard and Extended Numbered/Named Access Control Lists (ACLs) to block specific traffic types. Configure dynamic Network Address Translation (NAT) and Port Address Translation (PAT) to grant private hosts internet access.