Simrad Rf300 Installation Manual __hot__

The display will prompt you to turn the wheel manually to hard-over Port. Turn it until it stops, then press OK . Repeat the exact same process for hard-over Starboard.

Manually center the boat’s rudder to the exact dead-ahead position. Secure the wheel or tiller so it cannot move during installation. Step 2: Mount the RF300 Base simrad rf300 installation manual

Follow these step-by-step instructions to mechanically secure the feedback unit. Step 1: Set the Rudder to Midships The display will prompt you to turn the

transmitter lever until its alignment mark is opposite the cable entry into the unit. simrad rf300 installation manual

Check that the RF300 does not exceed its maximum mechanical limit (usually ±plus or minus 90 degrees, though the operational range is ±plus or minus 45 degrees). 4. Electrical Wiring and Connections